March 809-PL-HS-C 230 VAC Magnetic Drive Centrifugal Pump 0809-0180-0200
March 0809-0180-0200 809-PL-HS-C magnetic drive hydronic centrifugal pump with a 230V single-phase motor. Features a polysulfone front housing, stainless steel rear housing, center inlet design and a maximum flow of 7.5 GPM at 60 Hz. Designed for compatible hot water circulation and hydronic pumping applications.
March 0809-0180-0200 809-PL-HS-C Magnetic Drive Pump
The March 0809-0180-0200 is a 809-PL-HS-C 230V magnetic drive hydronic centrifugal pump designed for hot water circulation and compatible liquid-handling applications. Part of the March Series 809-HS, this pump features a center inlet configuration, a polysulfone front housing and a stainless steel rear housing.
Its 230V single-phase motor powers a magnetically coupled impeller without a conventional rotating mechanical shaft seal. The design helps reduce a potential leakage path while supporting dependable circulation in properly designed hydronic systems.
Key Features and Benefits
- Magnetic Drive Technology: Eliminates the conventional dynamic shaft seal for improved fluid containment.
- Center Inlet Design: Provides 3/8-inch female and 3/4-inch male threaded inlet connections.
- Polysulfone Front Housing: Provides the manufacturer-specified nonmetallic front wet end construction.
- Stainless Steel Components: Includes a stainless steel rear housing and shaft.
- 230V Single-Phase Motor: Designed for 50/60 Hz electrical operation.
- Hydronic Performance: Delivers up to 7.5 GPM flow and 12.1 feet of head at 60 Hz, at separate points on the pump curve.
Hydronic and Industrial Applications
The March 809-PL-HS-C is designed for compatible hot water booster and hydronic circulation systems. It may also be used in suitable OEM liquid circulation equipment where the pump materials, operating temperature and hydraulic performance meet application requirements.
Installation and Maintenance
Install the pump with adequate liquid supply and properly supported piping. This centrifugal pump is not self-priming, so it must be primed before operation. Avoid dry running, blocked flow and operation outside the manufacturer limits.
During maintenance, inspect the impeller, silicone O-ring, stainless steel shaft and Teflon thrust washer for wear or damage. Disconnect power, isolate pressure and allow hot liquid to cool before servicing.
Replacement and Ordering Guidance
Part number 0809-0180-0200 identifies the 809-PL-HS-C 230V complete standard pump. The 115V configuration uses a different part number, 0809-0180-0100.
Some suppliers identify 0809-0258-0200 as an updated motor version. Verify current availability, electrical compatibility, mounting and performance before selecting a replacement.
| Brand | March |
|---|---|
| Product Type | Pump |
| Application | Beer Pump |
| Inlet/Outlet Connection Type | MPT |
| Inlet Size | 3/4 in |
| Motor Hz Rating | 50/60 |
| Motor Voltage | 230 VAC |
| Outlet Size | 1/2 in |
| Max Flow | 7.5 gpm (28.4 lpm) |
| Max Head | 12.1 ft/ 2.5 m |
| Material - Wet End | Polysulfone |
| Max Head Range | < 15 ft |
The March 0809-0043-1000 is a Teflon thrust washer used in compatible March 809 magnetic drive pumps for reliable wet-end support and maintenance.
