March 0150-0214-0300 Magnetic Drive Centrifugal Pump 1/5 HP

This pump is a centrifugal magnetic drive pump, so no shaft seal is required. This centrifugal magnetic drive pump with no seals is ideal for chemical recirculation, chemical transfer, and scrubber systems. It has a maximum flow rate of 18 gallons per minute at 7 feet and a maximum head of 29 feet (12PSI). The materials that come into contact with the solution in the standard wet end are 316 Stainless Steel, Viton, and Ceramic. The inlet and outlet connections are 1 inch female pipe thread and 1/2 inch male. The pump can withstand a maximum internal pressure of 200 PSI and a maximum liquid temperature of 250 F or 121 C. The March TE-5S-MD centrifugal magnetic drive pump can handle chemicals, acids, and solvents that are mildly or highly corrosive. This pump does not self-prime, does not have a suction lift, and requires a flooded suction (the liquid must flow naturally to the pump). It cannot be run dry because the impeller is lubricated by the liquid being pumped. Never operate the pump until there is liquid inside it, and never run the pump dry. This pump's motor is U.L. listed and rated for continuous duty.